First of all, the straight bevel gear is the simplest one compared with the complex bevel gear. As we all know, bevel gears are generally designed as axially adjustable structures, so it will be more convenient to adjust the position of the ruler face contact area.In the middle of two bevel gears, each bevel gear can adjust its axial position by certain means during installation to facilitate changing its angle. In this way, more power can be transmitted. However, in actual operation, 1/3 of the tooth length is generally used as the working tooth length to avoid failure.

However, when there are no major problems in manufacturing and installation, a bevel gear that has not been repaired cannot be combined with normal operation. Otherwise, there will be some problems. The best way for bevel gears to operate together is to perform fine tooth repair.

It must be noted that this kind of bevel gear has a high requirement for accuracy. Once the accuracy cannot meet the requirements, it will cause noise or early failure, and even the risk of breaking.

Once this happens, there is basically no solution, so it must be noted that it is most suitable for installation. Generally speaking, you only need to remember the following points: First, near the different center contact areas, you must correct the tooth profile in the direction of the wheel to determine its direction and height. Let them form the so-called "drum nature" to make the problem easy to solve.

The above is an introduction to the basic installation points of bevel gears. If you need bevel gears, please consult the iHF Hefa gear manufacturer.